Edge Setter Stepper Joggler Joddler Panel Flanging & 5mm Hole Punch Sheet Metal Repair TE159

it works well after a few minor adjustments which took about 15mins as you can see from the photo it dose work and that’s 1mm steel the hole punch dose stick a little but wiggling from side to side soon frees it, for the money I would say it was good,

Only used these once very hard on your hands. You need to grip them very tight would recommend air one far better. These ok for small job.

Punch is stiff and takes 2 hands to push all the way through 0.9 mm mildsteel just as quick to drill the holes with a good drill bitThe crimper on the back doesn't clamp down enough to crimp the sheet steel in my opinion this product is of poor quality

I purchased these jogglers, i have to say they do not work, they hardly touched the metal and when you maned to get them as tight as possible it does not even bend the metal, i suppose if you want a hole punch that works but as for joggling, NOPE dont get these

Always wanted one of these for welding on my old car. Needs to be used with a bit of practice.

Awful tool, doesn`t work even on 0.8mm mild steel. Barely a flange after squeezing as hard as I could. Should have read the reviews before I purchased.

You need a seriously strong grip to use this... three punch holes and that was me done... returned it and bought an pneumatic...

Feels nice quality and does 2 jobs in one tool