CiT Alizarin PC Gaming Case, Mid-Tower ATX, Halo Single-Ring Rainbow Fan, RGB & Hub, Full Window and Mesh Front, For a Great Gaming Experience | Black

Was looking forward to this case since it did say 240mm water cooler in front and top. But turns out it's only in the front also by putting the cooling pump fans in the front you can't have a 3rd fan fixed to the case. Also it did say glass top and side but turns out it is acrylic which is already scratched and damaged on delivery. the discriptuon also says comes with one RGB 120mm fan which again was a lie and this case seems to already been used and sent back since the PCI back plates have already been removed. But if your not bothered about plastic top and side that's get scratched by your finger nail and not having a 120mm or 240mm water cooling fan and a chance it's 2nd hand then it might be ok. Just not worth £40

The main problem with this case is the lack of clearance on the back panel for cable routing etc, you have to use an uncomfortable amount of force to get it closed. I'd recommend building with fairly new PSU that has flat profile cabling and you'd have a better experience.Another big thing to consider is that the HDD caddy at the bottom is non-removable, so you have to remove the PSU to squeeze your hand in to screw your HDD's into the slots, not the best design. Or if you need to removed the cage to store unused PSU cables from a non-modular PSU you can't. Also be careful of all the SATA power cabling at this bottom corner as there is basically no room when you close the door. I have however, managed to 5 drives into this case, 2 SSD's had to be mounted in the main chassis though.Another thing is that the PCI slot metal covers can't be re-installed, you have to break off the metal to install your GFX card etc.. If you change your mind on the positioning or change your set-up, you'll have a big hole in the back of the case for that unused slot.I've since used the Fractal Meshify C case, which was a dream to build in and would highly recommend this case manufacturer instead.

2 120 in front 1 top to blow at cpu and one top to suck the hot air works like a charm for 25 pounds i just dont care for cases i am satisfied with that one as i would be with a 120 one

Was a extremely tight fit for mother board screw fitting could have been lined up much better. And side panel for wire's could do with being bigger so it closes.